SOLIS Deco Heater Plus - Manual (Page 21)

21
O P ER ATING INSTR UC TIO N
Firstly, connect the power cord to the correct power supply.
P ower switch (at the bottom of rear cover under the removable air filter)
Press the power button to “ I” position. If you heard the sound of “ didi” ,
the heater is ready to use. Press the button to « 0» position for turning off
the heater.
Handle
Back cover
Air filter
Power cord
O N/ O FF key
Press the« » key, the power indicating light will be turned on, the machine starts operation at low
heating power (LED indicator of the heating function shows « LOW » ). Press the key again, then all the
functions are stopped and the unit goes into the condition of standby mode and the power indicating
light will be turned off.
HE A T E R key
When the product is operated at low heating power, press the « » key, the high heating power will
be turned on, and the LED indicator will show « HIGH» . Pressing this key controls the selection of the low
heating power or the high heating power.
S W ING key (O scillation)
When the unit is under operating, press the « » key, the heater body will turn left and right automatically.
At the same time, the LED indicator of this swing function will be turned on. Press this key again, the
swing function will be stopped, and the LED light will be turned off..
S E T key
When the unit is under operating, pressing the « » key to set the temperature or time.
A : set the timer:
press the key, the the light will show “ 0 H” , then press the « + » or « -» key, to set the working time (within
a range of 1-12 hours). The time will be added or minus by 1 hour per every press of the « + » or « -» key, at
the same time, the displaying light will show the time you set.
Notice: when press the set key, the LED light will flicker per 0.5 second for 5 seconds. If there is no operation
to the keys after 5 seconds, or press other keys ex cept the « » , « + » , « -» key, then the LED indicator
will show the room temperature.
S et the temp erature:
When the timing setting finished, press the « » again, then the LED light will show 25° C, and now
you can set the temperature. Press the « + » , « -» key, to set the temperature (within a range of 15-35° C).
The temperature will be added or minus by 10° C per every press of the « + » or « -» key, at the same time,
the LED indicator will show the temperature you set.
Notice: when press the set key, the LED light will flicker per 0.5 second for 5 seconds. If there is no
operation to the keys after 5 seconds, or press other keys ex cept the « » , « + » or « -» key, then the LED
indicator will show the room temperature. When the room temperature is )-10° C, the LED indicator
will show as « LO» , when the room temperature is 40° C, the LED indicator will show as « HI» . When
the room temperature is between -10° C to 40° C, then the LED indicator will show the corresponding
temperature by number.
N.B.
When the temperature set is reached, the unit goes in stand-by mode, the power level indication
disappears and air circulation stops after 10 seconds. When the ambient temperature is 2° C below
the set temperature, the unit begins operating again at the same power level previously set.
Control P anel and
disp lay window
Low High
S E T
Low High
S E T
Low High
S E T
Low High
S E T Low High
S E T
Low High
S E T
Low High
S E T
Low High
S E T
Solis_DecoHeaterPlus_Betriebsanleitung.indd 2 1 11.0 4 .11 14 :4 8