Sonex Electric Instrument Installation Instructions - Manual (Page 4)

6. Oil Temp Set-up: Set the Oil Temp Probe to “Standard NTC”
7. Oil Pressure Set-up: Set the Oil Pressure Settings on the MGL Instruments to
the following: (Note: On the Jabiru 2200 and 3300, the Oil Pressure wire should
be attached to the terminal labeled “G)
Sender type: automotive, resistive
Resistance: 200 ohms
Resistance INCREASES with pressure
Sender Range: 80 PSI
9.General Grounding Practice: The ground wire for your Stratomaster (and all
your electronic equipment) should be run directly from the negative terminal on
your battery. Special note on RDAC ground (black wire from RDAC): This wire
should be grounded DIRECTLY to the engine block.
Please contact us anytime with questions at the numbers or e-mail below.
Sonex Aircraft, LLC
Phone: (920) 231-8297
Fax: (920) 426-8333
E-mail: [email protected]
http://www.sonexaircraft.com