Wing removal procedure, Step 1, Step 2 – Sonex Wing Installation/Removal Instructions User Manual
Page 12: Step 3, Step 4, Step 5, Step 6, Step 7, Step 8, Step 9
Wing Removal Procedure
Step 1:
Remove pitot tube and put the screws in a bag.
Step 2:
Disconnect the pitot lines at the wing root.
Step 3:
Remove control stick boots and bottom seat cushion.
Step 4:
Disconnect aileron pushrods from control stick horn.
Step 5:
While Supporting Flap, Disconnect flap push rods.
Step 6:
Remove hitch pin clips from all spar pins.
Step 7:
Remove rear spar pins.
Step 8:
With the left wingtip supported, pull the main spar pins halfway out (clear of one
spar).
Step 9:
Remove the left wing (one person on tip, one at root) and lay it on the ground.
Step 10:
With the right wingtip supported, remove the spar pins.
Step 11:
Being careful of the pitot tube, remove the right wing (one person on tip, one at
root) and lay it on the ground.