Sound Anchors ADMID - Manual (Page 4)

Assembling your uprights
1. Insert the end of one of the uprights into the rectangular opening in the top of the foot.
2. Use 2 each 7/16‐14 hex head cap screws with washers to fasten the upright to the foot.
3. Tighten the cap screws with a 5/8 inch wrench .
4. Repeat this opera on un l all of your uprights are assembled.
Assembling your speaker support
1. Insert 1 each 5/16‐18 x 1/2 socket head cap screw into the end of each speaker support bar.
2. A ach 2 support bars to each top weldment using 5/16‐18 x 3/4 socket head cap screws. Take care that the socket head cap
screws that you inserted in step one are both facing upward.
3. Depending on the width of your speakers we may have provided you with more than one set of moun ng holes for your speak‐
er support bars. The holes that you choose are your op on. The holes that you choose will depend on your setup.
Pu ng it all together.
1. Fasten the bo om weldment to the upright assembly using 3/8‐16 x 1/2 socket head cap screws.
2. Mount the speaker support assembly to the upright by inser ng a 7/16‐14 x 2 1/2 socket head cap screw and hardened wash‐
er through the slot in the one of the upright sand into the threaded hole in the end of the speaker support assembly. Choose a
spot near the top of the stand.
3. Lay the stand down on its side with the side with the speaker support assembly toward the floor.
4. Fasten the other end of the speaker support assembly to the other upright by inser ng a 7/16‐14 socket head cap screw and
hardened washer through the slot in the upright into the threaded hole in the and of the speaker support assembly. Snug up
this bolt.
5. Install spikes 3/8” washers and 3/8‐16 Jam nuts as shown in fig. 1 if using the op onal short black spikes and conecoasters
see fig.2
Fig. 1 Fig. 2