Tomei Powered TITANIUM MUFFLER - Manual (Page 7)

1. REMOVAL OF THE STOCK STANDARD EXHAUST MUFFLER
This manual only provides basic instructions. For more details please refer to the vehicles
official factory service manual.
1. Disconnect the car battery's negative terminal.
2 Remove the center muffler section and the main muffler.
3 Disconnect both rubber mounts from the right side of the main muffler.
2．INSTALLATION OF THE TOMEI TITANIUM MUFFLER
【Illustration of the mounting position of each bolt & gasket】
The installation of the supplied parts, are as shown below.
①
②
③
④
⑤※
⑨
⑥
⑩
⑫
⑪
⑦
⑧
⑤※
⑥
⑦
⑦
⑦
7
① MAIN PIPE A ⑧ SILENCER BAND
② MAIN PIPE B ⑨ SILENCER BAND RUBBER
③ SILENCER ASSY ⑩ FLANGE BOLT M8
④ GASKET ⑪ FLANGE NUT M8 【20.0∼28.0N・m (2.0∼2.9kgf-m)】
⑤ FLANGE NUT M10 【34.0∼39.0N・m (3.5∼4.0kgf-m)】 ⑫ SOUND REDUCER
⑥ CLAMP BAND 【25.0N・m (2.6kgf-m)】 ⑬ BUTTON BOLT M6 【8.0∼12.0N・m(0.8∼1.2kgf-m)】
⑦ SPRING
※Apply the Bolt Smooth Paste (included) to the parts which will be exposed to high temperatures.
This helps reduce the parts from sticking and seizures.
【Installation Procedure】
1. Test fit the Main Pipe A with the included M10 Flange nuts.
Now fit the pipe to the upper mounting portion of the stopper.
※Use the supplied gasket (④,shown above ) with the M10 Flange Nut (⑤,shown above).
2. Connect the Main Pipe B (whilst keeping the pipes parallel to each other) with the provided
spring hooks. Align both pipes before inserting the Main Pipe A. Then install the Muffler Hanger.
※Use the included Clamp Band (⑥, shown above).
3. Insert the Silencer Clamp Band onto the assembly, keep the pipes aligned so that they
are parallel with each other. Then insert Main Pipe B.
※Use the included Band Clamps (⑥, shown above).
Position the Silencer Assembly with the embossed logo facing down.
⑬
⑩
⑫
＜Kit contents torque specs ＞
7