Tomei Powered OVERSIZED FUEL PUMP (For FD3S) - Manual (Page 7)

KIT CONTENTS
Below is the contents of this kit with the quantity listed in brackets ().
REQUIRED TOOLS
These tools are the bare minimum required for the job.
・General Engine Maintenance Tools ・Workshop Service Manual
・Hose Cutter
CAUTION
■ These products are designed to be used for off road competition purposes only.
■ This product is NOT for use on public roads, due to safety risks. This product may not be road legal in your area.
■ This product is to be installed by a qualified professional in a fully equipped workshop.
■ If the attempt was made to use this product on another engine/car other than specified then you will risk
damaging this kit and or the engine or components related with it.
■ Do not overtighten the bolts when installing the product, you can risk damaging the bolt and or the product(s).
■ Only use the torque specs as specified in this manual or workshop service manual.
■ Please periodically inspect the tightened sections.
■ Do not use any excessive force when using this product as you risk damaging the product or other parts.
■ This product is to be installed with the appropriate tools and equipment to prevent any engine failures and injuries
or bodily harm.
WARNING
■ I ll h d l h h i & d i i i ld
Hose Band （2）
Fuel Hose （1）
Fuel Filter （1） Fuel Pump Unit （1）
Mounting clip (1)
Coupler （1） Terminal （2） Pump Insulator （1）
7
■ Install the product only when the engine & drive train is cold.
■ Due to the nature of the area where the product is installed. Please exercise caution to prevent any possible fire
hazards from oil etc.
WARNING Relating to Gasoline
Be careful with handing the fuel during the removal and re-installation of fuel line and components. Since it will be
a high fire and explosion hazard risk, always be sure that there is protection and safety equipement around at all
times.
■ The right place for the job is with the following attribute
① A well-ventilated place.
② Make sure that there is no fire risk hazard tools, equipement near the work space .
(lighters, electronic tools, welders)
③ Take precautions so that fuel vapors does not fill the work area.
■ Do not use anything that can cause sparks on the job.
① About electrical machinery and equipement.
・ As a general rule, do not use for this type of job or similar.
・ Do not test the pump and/or fuel in a plastic tank.
・ Do not use a drill, grinder and/or welder.
② Preventing sparks during the job.
・ Keep your work place spark free. (ie. Do not use a hammer).
■ Preventing static electricity, safe practices.
① Have a fire extinguisher prepared.
② Prevent static electricity.
・ Keep the floor slip free and free from water.
・ Keep the vehicles properly earthed when changing the fuel duct and components.
③ Keep the fuel separated when possible during the proceedure.
■ Have the fuel tank emptied before commencing work.
■ Take care not to spill the fuel that is left in the piping when removing the fuel lines.
■ Remove any unwanted foreign objects from the fuel tank when possible.
7