Tomei Powered FUEL RAIL - Manual (Page 13)

13
CAUTION
■ This product is designed for competition used ONLY. Not to be used on public roads.
■ This product will change the safety characteristics of the car and should not be used on public roads.
Doing so may break your local laws.
■ This product is to be fitted by an experienced professional in a fully equipped workshop.
■ This product is to be fitted with the correct tools, protective & safety equipment. Failure to do so can lead
to possible work hazards.
■ Refer to the vehicles original workshop service manual when disassembling the engine.
■ This product was specifically designed to be application specific. This is not a universal product.
If installed on any other vehicles/engines, this product may sustain damage and/or cause engine failure.
■ Pay attention to details before starting the job. Take care with the assembly process and perform the
tasks required with precision.
■ This product is to be installed when the engine is cold to prevent risk of burns.
■ Do not use excessive force when removing and installing parts. As this may cause damage to the parts
and related components.
■ Use the correct combination of related components to suit this new setup. The correct injectors, fuel
pump and ECU configuration.
■ Check for signs of fuel leaks and bleed the system properly before driving. Since this is related to fuel,
take care to avoid any fire hazards.
■ Always check the injectors manufacturers seal limit on the injectors used. Do not exceed the
manufacturers recommendations to avoid breaching the injectors pressure limits.
(REF) The information provided is based on the stock GTR injectors: below 4.5kg/cm 2
FUEL WARNING
With the nature of the product being with the fuel system, care is required to be sure that fuel is not
spilt or leaked during the installation. Be aware at all times the potential risk of fire and explosions.
■ Keep in mind your work environment before proceeding with the installation.
① A well-ventilated area.
② Be aware of potential fire risks (welders, grinders, electric motors etc.).
③ Confined areas that may collect fuel vapors.
■ Refrain from using anything that causes fire or sparks.
① Do not use any electrical equipment.
・ In general, do not use work lights.
・ When extracting fuel, do not use electrical pumps and plastic containers.
・ Do not use welders, heaters, grinders, drills & no smoking.
② Do not use anything that can cause sparks.
・Do not use anything like a hammer that could cause sparks.
■ Safety first.
① Have a fire extinguisher available at all times.
② To prevent static electricity.
・ Check that the floor is non slippery, spread a small amount of water on the floor.
・ Ensure that the vehicle is earthed when changing fuel, especially around the fuel tank.
③ Use a cloth to contain the fuel. But do not mix the cloths that contains fuel with the ones that do not.
■ Best to perform the job when there is minimal fuel left remaining in the fuel tank.
■ Drain the remaining fuel from the piping and remove the drain hose.
■ Take care to not allow any unwanted grime or foreign material from entering the fuel tank when performing the job.