Tomei Powered CARBON REAR BUNPER COVER - Manual (Page 3)

KIT CONTENTS REQUIRED TOOLS
Below is the contents of this kit with the quantity These tools are the bare minimum required
listed in brackets (). the job.
・ Double Sided Tape
Or
・Hand Drilled
・Riveted on
CAUTION
■ This product is designed to be used for off road competition purposes only.
■ This product is not to be used on public roads.
■ This product is to be installed by a qualified professional in a fully equipped workshop.
■ This product was designed specifically for the application specified. If the attempt was made to use this product
on another engine/car other than specified then you will risk damaging this kit and or the engine or components
related with it.
■ Do not use any excessive force when using this product as you risk damaging the product or other parts.
■ This product is to be installed with the appropriate tools and equipment to prevent any engine failures and
injuries or bodily harm.
WARNING
■ Install the product only when the exhaust is cold.
■ Please check that the product is installed properly and securely. Or there may be a risk of causing damage to
your car or other surrounding cars.
1. INSTALLATION
【INSTALLATION PROCEDURE】
1. Remove all signs of oil from the surface of the carbon
cover if you want to paint it to match the rest of your
bumper.
2. Fit it with a strong double sided tape, or pop rivet it on
with 10 rivets.
(Recommended:φ4.8mm Rivets/Clamp thickness t=4.0mm)
Or you can use both methods to ensure that the part
does not come off.
2. INSTALLATION VERIFICATION
1. Check to verify that there is nothing loose after the installation.
2. Run the car at idle, then raise the RPM to 2500rpm to verify that there are no abnormal sounds.
3. Verify the test runs are all cleared and free from any loose fitments signs and sounds.
WARNING
■ Drive the car slowly and carefully in the beginning to be sure that nothing comes off or falls off at high speeds.
■ If anything abnormal about the car is noticed when driving, please stop the vehicle immediately to check where
the problem is from.
■ Make sure that the muffler is cold before making any changes, adjustments and/or checks.
■ If any part(s) has fallen off the car or come loose. Do not run the car. Stop the engine immediately and call the
shop who installed to the product to check your cars condition before any problems escalate.
CAUTION
■ Check everything to verify that there are no loose parts after the installation has been completed.
Carbon Rear Bumper Cover (1)
Designed for this side
3