Trail Tech KTM DIGITAL FAN KIT 732-FN4 - Manual

010-ELV-164
Pre-08 4-Stroke KTM Fan Kit
Tech Support: 360-687-4530
[email protected]
PRE-2008 4-STROKE KTM FAN KIT
INSTALLATION INSTRUCTIONS
Fin Temp. Sensor
Wiring Harness
Thermal Grease
TTV Gauge
Fin Sensor Installed
STEP 1
STEP 2
STEP 3
Make sure the gas is shut off on the bike. Remove
seat, gas tank and radiator shrouds. Drain the coolant
out of the bike by removing the drain plug on the water
pump located on the right side of the engine. The drain
plug is the bolt on the water pump that has the copper
washer. Do not lose or damage the copper washer.
Remove the right radiator from bike.
Install the power harness, with built in fuse, directly to
the battery. (Red to Positive and Black to Negative).
Run harness along frame to the front of the bike. Make
sure to route wires where they will not be pinched or
rubbed.
Align fan bracket on the radiator to the mounting
tabs on the radiator. Use included screws to mount
the bracket to the radiator. Use a T20 Torx driver.
Recommended torque is 20 in-lbs (2.5 N-m).