Tri-Tronics Sport Upland G3 - Manual (Page 23)

Page 40
BASIC TRAINING INTRODUCTION
This training program, covering “Sit/Stay,” “Heel” and “Here” is also shown in the
Basic Training DVD included with all Field and Pro and Sport Series products and
features J. Paul Jackson of Lone Oak Retrievers.
When used properly, the e-collar is a very effective tool to aid your dog in reaching
its full potential. However, the use of an e-collar is not a short cut. It should be
used as part of an overall training program. Don’t make training sessions too
complex initially by training several commands during the same training session.
The dog will probably become confused and training could progress more slowly.
Dog training is part art – know when to go faster, slower and when to take a break.
E-COLLAR BASICS
Contact Points and Collar Position
Before you begin using your e-collar you must first select the correct contact point
length for your dog’s coat type. Be sure the receiver is turned on. Next place the
receiver on the dog in a position such that the receiver is under the dog’s neck.
The collar strap should then be pulled snug so the contact points of the receiver
make good contact with the dog’s skin. The collar should ride snugly in place
high on the dog’s neck.
Choosing the Right Intensity Level
Selecting the intensity suitable for training your dog is next. You should begin
using a low level of stimulation and observe the dog’s response. If there is no
reaction, such as a head shake, neck movement or just a change in expression,
increase intensity by one level. Keep increasing the level of stimulation until there
is a positive reaction from the dog. Please keep in mind that sometimes dogs will
vocalize due to the surprise of the electrical stimulation. But if the dog vocalizes
more than once, your level is too high for beginning training. Turn it down.
Page 39
The 9-volt battery in the Beeper is dead. Replace as needed.
The batteries in the receiver or transmitter need charging. Recharge as
recommended in the Remote Trainer Owner’s Guide.
Loose battery connection. Gently pull the metal tabs in the Beeper battery
compartment to hold the 9-volt battery more firmly.
You are using the wrong transmitter. If you own more than one Tri-Tronics
transmitter or train with someone who has a Tri-Tronics product, check that you
have not accidentally switched transmitters.
You are using a Remote Trainer model that does not have the Beeper control
feature. Check the Owner’s Guide for your model to determine if it can operate
a Tri-Tronics Beeper remotely. Or call our Customer Service Department to
find out.
Beeper Problem #3. The Beeper sound quality has become
muffled or distorted.
Dirt or debris has become trapped in the horn. Remove trapped debris as
described in the “Care and Maintenance” section.
Beeper Problem #4. The Beeper light is on but the Beeper
isn’t working.
The Beeper battery is getting low. Replace the battery.
Beeper Problem #5. The Beeper is changing modes on its own
or is turning itself on and off without receiving a signal from
the transmitter.
The Beeper battery is getting low. Replace the 9-volt battery.
Loose battery connection. Gently pull the metal tabs in the Beeper battery
compartment to hold the 9-volt battery more firmly.