Tri-Tronics Sport® Series Remote Trainers - Manual (Page 14)

FITTING THE COLLAR ON THE DOG
Place the collar strap in the middle of the dog’s neck. The
receiver should be on the underside of his neck. Place the
receiver so the light is facing forw a rd (toward the dog’s nose).
Tighten the buckle by holding it with two fingers as you pull
the strap snug. Do not put any fingers under the strap as
you tighten it. Always slip the free end of the collar strap
through any D-ring or keeper that is present, and both sides
of a double-sided buckle.
You can easily adjust the
strap for different sized necks
by sliding the receiver along
the strap. If the collar strap is
too long for your dog, you
can cut off excess strap
length. Leave enough length
to go through the D-ring or
keeper with about three inches
to spare. Note: Do not cut the
collar strap of the Sport ® 65 BPR S until after you have also
installed the Beeper on the strap.
Please note that Remote Trainers are not designed to be
worn continuously by a dog. To prevent irritation caused
by rubbing, remove the collar for at least eight hours out
of every 24-hour period. See the important message about
avoiding skin irritation on page 20.
Page 10 Sport ® Series
To tighten the collar on the
dog, hold the buckle as shown
and draw the strap snug.
Remote Trainers need to be
snug for consistent stimulation.