Castelle FAXPRESS PREMIER 61-1260-001A - Manual (Page 19)

Setting Up the FaxPress Premier Digital
17
To change the Premier’s default digital board configuration to match
your T-1 line’s configuration, follow these steps:
1. Attach a mouse, keyboard, and monitor to the FaxPress Premier
Digital. Although Remote Desktop can be used for configuring
other aspects of the Premier system, it can’t be used for this.
2. Power on the Premier Digital.
3. Log into the Premier system as Administrator . The default pass-
word is castelle . Make sure castelle is all lower case.
4. Open the Services directory. ( Start>Settings>Control
Panel>Administrative Tools>Services .)
5. Stop all Castelle services.
6. Stop the GammaLink System service.
7. Stop the Dialogic System Service .
8. Use Windows Explorer to browse to the C:\Program Files\Dia-
logic\Data directory.
9. Find the group of three .config , .pcd , and .fcd files that corre-
spond to your T-1 line. Start by looking in the gdk_T1 T-1 list. If
your T-1 is ISDN, find the group files related to T-1 ISDN, and
then find the three
.config , .pcd , and .fcd files that specifically
match your T-1 ISDN’s configuration.
10. Select the group of group of three .config , .pcd , and .fcd files
that apply to your T-1 line and make backup copies of them.
11. Use Notepad to open the .config file, modify it with your T-1’s
specific Line Coding and Framing parameters, and save it.
12. From a command prompt, change directory to C:\Program
Files\Dialogic\Bin , and type:
fcdgen c:\program files\dialogic\data\modified_
config_filename.config
where modified_config_filename.config is the one you just modi-
fied in step 11.
13. Press Enter to generate a new .fcd file, filename.fcd .