Two Brothers Racing Suzuki GSX-650F - Manual

V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Parts List
IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualified
motorcycle technician. If you have any doubts as to your ability to install this
performance part, please consult with your local motorcycle dealer. Read all
instructions first before starting installation. Make sure the motorcycle and
exhaust system are completely cool before starting the installation. Also,
make sure the bike is secure on a centerstand or ideally a service lift during
installation. Be sure to save all stock components for possible use later.
Installation Instructions
2008 Suzuki
GSX-650F
V.A.L.E.™ Slip-on Exhaust System with M-2 Canister
Part # 005-1940406V, 005-1940407V, 005-1940408V
Qty. Description Part Number
1 M-2 Muffler Canister Varies
1 Muffler Clamp Varies
1 Stainless Steel S-Bend Slip-On Tube 005-19401V
1 HARDWARE KIT 005-194-3
2 X-Ring (half) 005-7-2-3
1 66mm Barrel Clamp 005-27-66MSH
1 5mm Long Handle Ball end hex key 005-9-18610
1 T20 Torx Hex Key 005-9-15820
4 6x14mm Socket Head Cap Screw 005-SH614
4 6mm Split Washers 005-WL6
1 TBR Sticker Kit 015-10212
Make sure the bike is completely cool before starting
the installation. Make sure the bike is secure on a
centerstand or ideally a service lift.
Remove the OEM muffler assembly.
Attach the TBR slip-on tube to muffler using the 4
6x14mm socket head cap screws and 6mm split
washers provided. Leave loose for now.
Slide barrel clamp on the end of the slip-on tube.
Install the TBR muffler assembly to the motorcycle
using the OEM muffler mounting hardware.
Once everything is aligned, tighten muffler mount,
then the 4 6x14mm V.A.L.E.™ bolts, and barrel
clamp last.
Double check your work, clean off finger prints from
exhaust tube.
Before you run the bike, clean off all fingerprints
and dirt, as any oily residue will etch the metal and
become somewhat permanent when the system
gets hot. Run the bike and enjoy. It is normal for
some white smoke to appear the first time you start
the bike. This is packing/manufacturing oil from
inside the pipe burning off. Check for gaps or leaks.
If you find a leak, a little high temperature silicon
sealant should fix it. After 50 to 100 miles, recheck all
fasteners for tightness.
1.
2.
3.
4.
5.
6.
7.
8.
(Continued on page 2)
Muffler Inlet
X-Lite™ Ring
Slip Tube
V.A.L.E.™ Assembly Detail
Warranty
two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as is”
without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a particular
purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use
of these products or parts.