Two Brothers Racing Triumph Street Triple - Manual

Play with rotation of slip-on tube to align mufflers and
tighten muffler clamps, X-Ring bolts and OEM joint
clamps at header assembly.
Make sure you have adequate clearance of all parts and
exhaust is coming out above turn signals.
Re-install removed parts.
Double check all your work.
Before you run the bike, clean off all fingerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Also,
remove any plastic film from the name badge(s) and or
canister clamp(s). Run the bike and enjoy. It is normal for
some white smoke to appear the first time you start the
bike. This is packing/manufacturing oil from inside the
pipe burning off. Check for gaps or leaks. If you find a leak,
a little high temperature silicon sealant should fix it. After
50 to 100 miles, recheck all fasteners for tightness.
8.
9.
10.
11.
12.
IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance
part, please consult with your local motorcycle dealer. Read all instructions first
before starting installation. Make sure the motorcycle and exhaust system are
completely cool before starting the installation. Also, make sure the bike is secure
on a centerstand or ideally a service lift during installation. Be sure to save all stock
components for possible use later.
Installation Instructions
Make sure the bike is completely cool before starting the
installation. Make sure the bike is secure on a centerstand
or ideally a service lift.
Remove seat.
Remove left and right rear tail section.
Remove left and right mufflers.
Install left and right hanger brackets.
Install TBR slip-on tubes to mufflers by loosely attaching
the X-Ring to the mufflers using the 6x14mm socket head
cap screws and lock washers provided. Leave loose for
now.
Attach mufflers to motorcycle using the rubber lines
muffler clamps and flange bolts provided. Leave loose
for now.
1.
2.
3.
4.
5.
6.
7.
Qty. Description Part Number
2 Muffler Canister Varies
2 Muffler Clamp Varies
1 Slip-on Tube left 005-24804L
1 Slip-on Tube right 005-24804R
1 HARDWARE KIT 005-248-3
2 X-Ring 005-7-2-2
8 6x14mm Socket Head Cap Screw 005-SH614
8 6mm Split Lock Washer 005-WL6
1 Mounting Bracket left 005-248HB-L
1 Mounting Bracket right 005-248HB-R
2 8x20mm Flange Bolt 005-FB816
2 8mm Flange Nut 005-FN8
1 T20 Torx Screw Hex Key 005-9-15820
1 5mm Long Handle Ball End Hex Wrench 005-9-18610
1 TBR Sticker Kit 015-10212
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Continued on pg. 2
2008-09 Triumph
Street triple
V.A.L.E.™ Dual Slip-on Exhaust System with M-2 Canisters
Part # 005-2480406DV, 005-2480407DV, 005-2480408DV
Parts List