Two Brothers Racing Yamaha Raptor 250 Dyna FS Ignition - Manual

DYNATEK DFS7-28
2008+ YAMAHA RAPTOR 250
10,500 RPM LIMIT (9,500 stock Raptor 250)
CAUTION: This ignition will increase the engine rev-limiter!
Congratulations on your purchase of a Dynatek ignition. Please take a moment to read these instructions completely before
installing the ignition. The installation will only take about ten minutes, but proper setup for your specific vehicle may take longer.
The DynaFS ignition was designed to work best with the Dynatek coil (or stock coil) with the stock coil wire, plug cap, and spark
plug. Use the stock resistor style spark plug cap and resistor spark plug.
Installation
This kit includes: DynaFS ignition and instruction sheet. This is a complete kit, and includes everything needed to install the
ignition. Route the electrical harness carefully.
1. Turn ignition key off, remove the seat. Remove the tool kit. Remove the battery cover (two 10mm bolts).
2. Remove the stock ignition and disconnect it by unplugging the stock connector. Place the stock ignition in a secure
location, it maybe needed for troubleshooting.
3. Connect the DFS Ignition to the stock vehicle connector.
4. Mount the DFS Ignition behind the seat latch (See Picture1).
5. Route the DFS Ignition harness carefully along the left side of the battery (See Picture2).
6. Install the battery cover and replace the tool kit.
7. Installation is complete! Double-check your wiring and secure all loose wires using tie-wraps.
Calibration
The DynaFS is pre-programmed with a single performance advance curve, and a 10,500 RPM rev-limit. A quicker throttle
response and increased power over the stock curve is achieved. For other advance curve information, see the attached Advance
Chart. This ignition will allow the engine to rev to a higher RPM. Because the rev limit is increased, the performance limits of
other engine parts (valve train or piston for example) may be found. It may be necessary to replace these parts for best engine
performance.
Picture 1: Picture 2:
DYNATEK 164 S. Valencia St., Glendora, CA 91741 800-928-3962 www.dynaonline.com
2801384A