Cisco WIRELESS LAN CONTROLLER OL-17037-01 - Manual (Page 23)

7-23
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 7 Controlling Lightweight Access Points
Autonomous Access Points Converted to Lightweight Mode
Step 10 To view details about the access points that are provisioned using LSC, enter this command:
show certificate lsc ap-provision
Information similar to the following appears:
LSC AP-Provisioning........................... Yes
Provision-List................................ Present
Idx Mac Address
--- ------------
1 00:18:74:c7:c0:90
Using the GUI to Authorize Access Points
Using the controller GUI, follow these steps to authorize access points.
Step 1 Click Security > AAA > AP Policies to open the AP Policies page (see Figure 7-6 ).
Figure 7-6 AP Policies Page
Step 2 If you want the access point to accept self-signed certificates (SSCs), manufactured-installed certificates
(MICs), or local significant certificates (LSCs), check the appropriate check box.
Step 3 If you want the access points to be authorized using a AAA RADIUS server, check the Authorize MIC
APs against auth-list or AAA check box.
Step 4 If you want the access points to be authorized using an LSC, check the Authorize LSC APs against
auth-list check box.
Step 5 Click Apply to commit your changes.
Step 6 Follow these steps to add an access point to the controller’s authorization list:
a. Click Add to access the Add AP to Authorization List area.
b. In the MAC Address field, enter the MAC address of the access point.