Setting up, Choosing the power sources, Connecting the ac power cord – Sony CFD-V35 User Manual
Page 18: Inserting batteries into the remote, Insert two size aa (r6) batteries (not supplied), Replacing batteries, Using the player on batteries
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Up
Choosing the
power sources
You can use the AC power or batteries as
a power source.
Use the AC power source whenever you
record since recording consumes much
power.
AC IN
Notes
• When you operate the
player with the
batteries, you cannot
turn on the player
using the remote.
• When you operate the
player with the
batteries, the back light
does not light even if
the player is on.
Tip
Replace the batteries
when the OPR/ВАТТ
indicator dims or when
the player stops
operating. Replace all
the batteries with new
ones. Before you
replace the batteries, be
sure to take out the CD
from the player.
1 8 Setting Up
Connecting the AC power cord
Insert one end of the supplied AC power cord to the
AC IN socket located at the rear of the player, and the
other end to the wall outlet.
Inserting batteries into the remote
Insert two size AA (R6) batteries (not supplied)
Replacing batteries
With normal use, the batteries should last for about
six months. When the remote no longer operates the
player, replace all the batteries with new ones.
Using the player on batteries
Insert six size D (R20) batteries (not supplied) into the
battery compartment.
To use the player on batteries, disconnect the AC
power cord from the player.