Sony RM-V21 - Manual (Page 6)

Searching for the Correct Code
If you've tried all the code numbers listed for your component
and you still cannot get the Commander to work, try these
steps:
1 Using the component's original remote control (or the
power switch on the component itselO, power on the
component.
2 Set the slide switch on the Remote
Commander to the position of the
component that you want to set up. CBL- L-^TlJirg-VCR
3 Press and release the SET button.
4 Press and release the CH-f button. Then
press and release the POWER button.
CH
power )
Repeat step 4 until your component powers off.
Pressing CH+ and POWER repeatedly will try eveiy
available code until the correct one is found. Be patient as
you do this; it may take 50 or 60 tries until the correct code
number is locatecl.
[EMT]
VOL CH
6 When the coniponent powers off, press and
release the ENT button to store the code
number in the Commander's memory.
7 Check that the Commander is operating
the other functions of your component.
Turn on the component again; then press
the channel and volume control buttons.
If it seems to be working properly, you're
done selling up the Commander.
If you still cannot get the Commander to work properly, see
'Troubleshooting" on page 22.
10
S «
Setting Up Video Components That
Are Connected to an Audio System
The Remote Commander is factory preset based on the
assumption that you play the audio portion of your video
programs through your TV's speakers, and that you play your'
audio components through your receiver (or amplifier).
This feature lets you control the volume of your components
without first having to change the Factory Preset
Commander's slide switch to
the component's audio
source.
Position Audio Plays Through:
CBL TV
TV TV
VCR TV
AVI Receiver/amp
AV2 Receiver/amp
For example, to control the
volume for your VCR
programs, you don't need to
change the slide switch from
VCR to TV. Likewise, to
control the volume for your
CD player, you don't need to move the slide switch from the
CD position to the receiver position (AVI or AV2).
Changing the Factory Preset Audio Source
If your video components are connected to an audio system,
you probably play your TV and VCR's audio through your
audio receiver, instead of your TV speakers. If so, you can
change the factory preset so that you can control the volume of
your video components without first having to switch to the
receiver (AVI or AV2). To change the factory preset audio
source for your video components, follow the procedures in
"Setting Up a Video Component That's Connected to an Audio
System" on page 12.
11