Sony CDP-XA7ES - Manual (Page 16)

16
Recording From CDs
IKKI/t>t>ll Е01ТЯ1МЕ FADE
Press EDIT/TIME FADE before you start playing
as follows:
• To select Time Edit, press the button once.
"EDIT" appears and "SIDE-A" flashes in tiLe
display.
• To select Just Edit, press the button twice.
"JUST EDIT" appears and "SIDE-A" flashes in
the display.
Press KM or >C>I1 to specify the tape length.
Each time you press these buttons, the display
changes as shown below, with the tape length of
one side following each indication.
• HALF C-54 ^ C-60 C-74 C-90 . h
(23.00) (27.00) (30.00) (37.00) (45.00)
When you select "HALF"
The player sets the program of each side to a half of the
total playing time of the disc. Note that you cannot select
"HALF" when the disc has more than 24 tracks.
Press EDIT/TIME FADE to have the player create
the program.
The display shows the tracks to be recorded.
"SIDE-B" flashes in the display.
When you record on both sides of the tape, press
EDIT/TIME FADE again.
The player inserts a pause, then creates the
program for side B. The display shows the
programmed tracks.
When you record on one side of the tape or on a
DAT or MD, skip this step.
Start recording on the deck and then press ► on
the player.
When you record on both sides of the tape, the
player pauses at the end of the program for side A.
6
When you record on side B, reverse the tape and
press ► or II on the player to resume playing.
To cancel Time Edit/Just Edit
Press PLAY MODE repeatedly until "SHUFFLE",
"PROGRAM" and "CUSTOM INDEX" disappear from the
display (or press CONTINUE on the remote).
I
'Q' You can program the tracks you want in advance
Select the tracks before doing the above procedure. The
player creates a program from the remaining tracks. In
this case, you cannot select "HALF" to specify the tape
length.
'Q' You can freely specify the tape length
Set the tape length using number buttons. T^- cnt-jT-D."
use button 10.
Example: When the tape length of one side is 30 minutes
and 15 seconds
Press 3,10,1 and 5.
'Q' When tracks, which aren't numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
You can automatically insert a blank space of 3
seconds between each track
Use the Auto Space function (see page 18).
'Q' You can check and change the program
See page 14.
Fading In or Out
You can manually fade in or out to prevent tracks from
starting or ending abruptly.
Note that you cannot use this effect when you use the
DIGITAL OUT connector.
CDP-XA5ES/XA3ES
□
@ OD
0 о о о о о
о ••
R Г t Г" 1 • ||
IKKI/I»! Number buttons Е01ТЯ1МЕ FADE
Number buttons-
□ cn
□ CD
CD
CD CD CD
CD CCD CD
CD CCD (CD
CD CD CD
CD CD
CD CD CD CD CD
CD CD CD
CD|CD
CD
CD CD
CD
CD
(CD CD CD
(CD
CD
FADER