Sony MDS-JE700 - Manual (Page 32)

Editing Recorded MDs
Labeling tracks and MDs with the remote [X]
NAME
0
oo
O
O O O O O
O O O O O
O O O O O
O O O O O
O O O O O
O O O O O
, Alphabet/number
buttons
CLEAR
NUM
4
Repeat Steps 2 and 3 until you have entered the
entire title.
If you entered the wrong character
Press or ►► until the character to be corrected
starts flashing. .
Press CLEAR to erase the incorrect character, then enter
the correct one.
5
Press NAME again.
The entered title appears on the left side of the
display window after the label has been recorded.
To cancel labeling
Press ■.
1
Press NAME repeatedly until a flashing cursor
appears in the display, then do the following:
Changing an existing title [1
To label Make sure that the deck is
A track Playing, pausing, recording the track
to be labeled, or stopped after
locating the track to be labeled
An MD Stopped with no track number
appearing in the display
Select the character type as follows:
To select Press
Uppercase letters CHAR repeatedly until "Selected
ABC" appears in the display
Lowercase letters CHAR repeatedly until "Selected
abc" appears in the display
Numbers NUM repeatedly until "Selected
123" appears in the display
1
Press NAME, then do the following:
To change Make sure that the deck is
A track title Playing, pausing the track whose title
is to be changed, or stopped after
locating the track whose title is to be
changed
A disc name Stopped with no track number
appearing in the display
2
Keep pressing CLEAR (or EDIT/NO on the deck)
until the current title is erased.
3
Enter the new title.
Do Steps 3 to 6 of "Labeling Recordings" on page
31, or Steps 2 to 4 of "Labeling tracks and MDs
with the remote" on this page.
4
Press NAME.
3
Enter one character at a time.
After you enter a character, the cursor shifts
rightward and waits for the input of the next
character.
32