Sony CDX-C8850 - Manual (Page 22)

Adjusting the volume of
the subwoofer(s)
1
Press f source 1 to select a source (tuner,
CO, or MO).
2
Press f SOUND) repeatedly until 'SUB'
appears.
SUB ® @
a........II---- a
3
Rotate the.dial to adjust the volume.
After three seconds, the display returns to
the normal playback mode.
Tip
When you rotate the dial to turn the volume all
the way down, 'Sub ATT' appears and the cutout
frequerKy of the subwoofer is disabled.
Adjusting the frequency of the
subwoofer(s)
To match the characteristics of the cormected
subwoofer(s), you can cut out the unwanted
high and middle frequency signals entering
the subwoofer(s). By setting the cut-off
frequency (see the diagram below), the
subwoofer(s) will output only low frequency
signals so you can get a clearer sound image.
1
Press (SOUND) for two seconds.
2
Press (SOUND
)
repeatedly until "SUB"
appears.
3
Press
® (^)
■
m —
LPF off
4
Rotate the dial to select the desired cut­
off frequency.
The cut-off frequency in the display
changes as follows:
62 Hz 78 Hz <
»—off . 99 Hz »— 125 Hz —» 157 Hz
If you want to adjust the volume of the
subwoofer(s), press d5 (♦—) and rotate the
dial as in step 3 of "Adjusting the volume
of the subwoofer(s)."
Press (SOUND) for two seconds.
After the frequency setting is complete, the
display returns to the normal playback
mode.
Listening to each
programme source in its
registered DSO
— Source Sound Memory (SSM)
Each time you return to the same source, you
can hear the same DSO menu and equalizer
curve registered for that source, even after
changing the programme source or turning the
unit off and then on again.
22