Specifications, Audio power specifications, Amplifier section – Sony STR-V220 User Manual

Page 18: Power output, Frequency response, Inputs, Sensitivity impedance s/n, Weighting network, input level), Fm tuner section, Antenna terminals

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Additional Information

Specifications

AUDIO POWER SPECIFICATIONS

POWER OUTPUT AND TOTAL
HARMONIC DISTORTION

With 8 ohm loads, both
channels driven, from 20 -
20,000 Hz; rated 60 watts
per channel minimum RMS
power, with no more than
0.3% total harmonic
distortion from 250
milliwatts to rated output.

Amplifier section

POWER OUTPUT

stereo mode

(8 ohms 20 Hz - 20 kHz,

THD 0.3%)

60 W + 60 W

Surround mode

(8 ohms at 1 kHz, THD

0.08%)

Front: 60W/ch
Center*: 60 W
Rear*: 60W/ch
* Depending on the

surround mode and the
source, sound will not be
output.

Frequency response

CD, TAPE/MD, TV/SAT,

VIDEO:

10 Hz - 50 kHz ±1 dB

Inputs

Sensitivity Impedance S/N

(weighting
network,
input level)

CD

200 mV

Outputs

TAPE/MD REC OUT:

Voltage: 150 mV,
Impedance: 10 kilohms

VIDEO AUDIO OUT:

Voltage: 150 mV,
Impedance: 10 kilohms

MIX AUDIO OUT:

Voltage: 2 V
Impedance: 10 kilohms

PHONES:

Accepts low and high
impedance headphones

MUTING

Full mute

BASS BOOST

+10 dB at 70 Hz

TONE

±8 dB at 100 Hz and 10 kHz

FM tuner section

Tuning range

87.5 -108.0 MHz

Antenna terminals

300 ohms, balanced
75 ohms, unbalanced

Sensitivity

Mono: 18.3 dBf, 4.5 pV

Stereo: 38.3 dBf, 45 pV

Usable sensitivity

11.2 dBf,2pV (IHF)

S/N

Mono: 76 dB

Stereo: 70 dB

Harmonic distortion at 1 kHz

Mono: 0.3%
Stereo: 0.5%

Separation

45 dB at 1 kHz

Frequency response

30 Hz -15 kHz dB

Selectivity

60 dB at 400 kHz

AM tuner section

Tuning range

With 10 kHz interv'al: 530 -

1710 kHz**

Antenna

Loop antenna

Usable sensitivity

50 dB/m (at 1,000 kHz)

S/N

54 dB (at 50 mV/m)

Harmonic distortion

0.5% (50 mV/m,

400 Hz)

Selectivity

At 10 kHz: 40 dB

** You can change the AM tuning

interval to 9 kHz or to 10 kHz. After

tuning in any AM station, turn off

the receiver. Hold down the

TUNING + button and press the 1/(1)

button. All preset stations will be

erased when you change the

interval. To reset the interval to 10

kHz, repeat the procedure.

General

Power requirements

120 V AC, 60 Hz

Power consumption

130 w

AC outlets

1 switched, 120 W/1 A

maximum

Dimensions

355 x 120 x 325 mm

(14 X 4

^/4

X 12

^/4

inches)

including projecting parts
and controls

Mass (Approx.)

5.7 kg (12 lb 10 oz)

Supplied accessories

See page 4.

Design and specifications are subject to

change without notice.

TAPE/MD,

150

mV

TV/SAT,
VIDEO

82 dB

50 kilohms (A, 150

mV)

18

Advertising