Sony STR-V220 - Manual (Page 12)

Receiver Operations
If you cannot tune in a station and the entered
numbers are flashing
Make sure you've entered the right frequency. If not,
press DIRECT and reenter the frequency you want.
If the entered numbers still flash, the frequency is not
used in your area.
Q' To watch FM simulcast TV programs
Make sure that you tune in the simulcast program on
both the TV (or VCR) and the receiver.
If you enter a frequency not covered by the tuning
interval
The entered value is automatically rounded up or down
to the closest covered value.
Tuning intervals for direct tuning are:
FM: 50 kHz intervals
AM: 10 kHz intervals (To change to 9 kHz intervals, see
page 18.)
Presetting Radio Stations
You'll most likely want to preset the receiver with the
radio stations you listen to often so that you don't have
to tune in the station every time. The receiver can store
a total of 30 FM or AM stations. You can store the
stations on preset numbers combining 3 characters (A,
B and C) and numbers (0 to 9). For example, you can
store a station as preset number Al, B6, or C9.
SHIFT TUNER
Receiving broadcasts by scanning stations
(automatic tuning)
If you don't know the frequency of the radio station
you want, you can have the receiver scan all the
receivable stations to .locate the one you want.
1
Press TUNER.
The last received station is tuned in.
2
Press FM/AM to select FM or AM.
3
Press TUNING + or
Press the + button for a higher station number;
press the - button for a lower one. When you tune
past either end of the band, the receiver
automatically jumps to the opposite end and
continues scanning in the same direction. Every
time a station is received, the receiver stops
scanning. To continue scanning, press the button
again.
1
Press TUNER.
The last received station is tuned in.
2
Tune in the station you want.
If you are not familiar with how to tune in a
station, see "Receiving Broadcasts" on page 11.
3
Press MEMORY.
"MEMORY" appears for a few seconds.
Do Steps 4 and 5 before "MEMORY" goes oiit.
4
Press SHIET to select a memory page (A, B or C).
Each time you press SHIFT, the letter "A," "B," or
"C" appear in the display.
5
Press the number you want to use (0 to 9).
If "MEMORY" goes out before you specify the
preset number, start again from Step 3.
6
Repeat Steps 2 to 5 to preset other stations.
To change a preset station
Preset a new station on the number you want to
change.
Note
If the AC power cord is disconnected for about one week,
the preset stations will be cleared from the receiver's
memory, and you will have to preset the stations again.
12