Sony STR-V220 - Manual (Page 6)

Getting Started
Audio Component Hookups
Overview
This section describes how to connect your audio
components to the receiver. If you want to use the
receiver as an amplifier, complete these connections.
CD TAPE/MD
What cords will I need?
Audio cords (not supplied) (1 for a CD player; 2 for a tape
deck or MD deck)
White (L)
Red (R)
Hookups
The arrow
CD player
White (L)
Red (R)
indicates signal flow.
Receiver CD player
Tape deck or MD deck
Receiver Tape deck or MD deck
Speaker System Hookups
Overview
This section describes how to cormect your speakers to
the receiver. Although front (left and right) speakers
are required, center and rear speakers are optional.
Adding center and rear speakers will enhance the
surround effects. Connecting an active woofer will
increase bass response.
REAR FRONT
MIX CENTER
For optimum surround sound effect, place your
speakers as shown below.
Rear speaker
What cords will I need?
• Speaker cord (not supplied) (1 for each speaker)
(+)
(-)
(+)
(-)
Twist the stripped ends of the cord about 2/3 inch (15
mm). Be sure to match the speaker cord to the appropriate
terminal on the components: + to + and - to -. If the cords
are reversed, the sound will be distorted and will lack
bass.
Monaural audio cord (not supplied) (1 for an active
woofer)
Black =CZ3jIiZD= =c3ffn= Black