Clarion SA200 - Manual (Page 4)

d
4
I N S T A L L A T I O N G U I D E
C o n v e r t i b l e V e h i c l e I n s t a l l a t i o n s
On convertible vehicles (and some sedans that don't have sufficient space under the window moldings) the
antenna module should be mounted on the center of the trunk lid approximately 6 inches away from the
rear window.
1. Follow Step 1-4 of Sedan Vehicle Installation.
2. Route the cable from the antenna along the edge of the trunk lid underneath the lid. (Cable clamps
maybe necessary to hold the antenna cable in place when access holes on the trunk lid aren't available.)
3. Wire tie or run the antenna cable through an existing wiring loom leading from the trunk lid to the interior
of the trunk. (It might be necessary to remove the plastic housing from the antenna connector in order to
feed the cables through narrow openings.)
4. Route the cable through the interior trim to where the receiver is located.
It is important that the coaxial cable is not damaged or kinked during the installation procedure.
S U V / M i n i v a n / 5 - D o o r V e h i c l e I n s t a l l a t i o n s
The antenna module should be mounted on the centerline of the roof, not less then 4 inches away from the
gap between the roof and tailgate. If the vehicle is equipped with a roof rack, the crossbar should be placed
at least 6 inches away from the antenna module. In certain instances, it maybe necessary to mount the
antenna left or right of center to avoid "skid ribs" or the brake light.
1. Follow Step 1-4 of Sedan Vehicle Installation.
2. Route the cable from the antenna between the roof and tailgate to the inside of the vehicle. Take
advantage of any existing cable channels or wiring conduit.
3. Route the cable between the headliner and sheet metal by lifting up and/or removing the rubber molding
and going through the small opening between the sheet metal and headliner.
4. Route the cable through the interior trim to where the receiver is located.
It is important that the coaxial cable is not damaged or kinked during the installation procedure.