Chicago Electric 10" Ramdon Orbit Polisher/Waxer 43424 - Manual (Page 10)

SKU 43424 For technical questions, please call 1-800-444-3353. PAGE 10
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on page 14
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram on page 14.
1. CAUTION: Always make sure the Power Cord (part #25) of the Polisher/Waxer is
unplugged from its electrical outlet
prior to making any adjustments to the tool.
2. Place a clean terry cloth Waxing Bonnet (part #30) securely onto the Pad
(part #20). (See Figure D, next page.)
3. NOTE: Prior to waxing/polishing a vehicle, make sure it’s surface has been
thoroughly cleaned and is free of dust, dirt, oil, grease, etc.
4. Apply about two tablespoons of wax (not included) evenly on the terry cloth
Waxing Bonnet (part #30). Do not apply the wax directly to the surface of the
vehicle. The amount of wax needed will vary according to the size of the vehicle
being waxed. NOTE: Avoid using too much wax. For additional applications of
wax to the Waxing Bonnet, reduce the amount of wax. The Waxing Bonnet will
not absorb as much wax in subsequent applications. (See Figure D.)
5. Plug the Power Cord (part #25) of the Polisher/Waxer into an electrical extension
cord (not included). Then, plug the extension cord into a grounded, 120 volt,
electrical outlet. (See Figure D.)
6. In order to keep the extension cord out of the way, hang it over your shoulder.
7. NOTE: Always start and stop the Polisher/Waxer while it is held firmly against the
surface of the vehicle. Failure to do so may result in the Waxing Bonnet
(part #30) being thrown from the Pad (part #20). (See Figure D.)
8. Grip the Polisher/Waxer firmly with both hands. Then turn the Power Switch
(part #26) to its “ON” position and allow the Pad (part #20) to rotate to its fullest
speed. (See Figure D.)
9. Begin applying wax to the vehicle. Apply the wax to all flat surfaces with broad,
REV 06/05
IMPORTANT
Carefully inspect the condition of the accessory before use and check the accessory
continually during use. If any damage is noted, stop immediately and replace the accessory
with an undamaged one. Harbor Freight Tools cannot be held responsible for damage
caused by using a damaged accessory on this tool.