Compatible Systems OCTAL V.35 - Manual (Page 5)

Introduction to the Octal V.35-10/100 RIOP 1
Introduction to the Octal V.35-10/100 RIOP
The Octal V.35-10/100 Routing Input/Output Processor (RIOP), as part of the VSR multigi-
gabit switching router, allows you to connect a local Ethernet and up to eight remote corporate
networks. Each of the V.35 interfaces has a data capacity of up to 2.048 Mbps, while the
Ethernet interface can operate at either 10 Mbps or 100 Mbps.
This section of the manual contains information specific to the Octal V.35-10/100 RIOP. It is
divided into the following sections:
Chapter 1: Network Installation
Here you will find step-by-step instructions on how to physically install the Octal V.35-10/100
and connect it to your network.
Chapter 2: Quickstart Configuration
The Quickstart section provides a basic list of parameters that must be entered into the Octal
V.35-10/100 for proper operation.
Chapter 3: Shipping Defaults
This section of the manual lists factory defaults for the interfaces.
Chapter 4: LED Patterns
This section of the manual describes the LED indicators for the Octal V.35-10/100.
Appendix A: Cable Pin Outs
This section of the manual describes the pin-outs for the V.35 connector cables.