COBY TFTV1525 - Manual (Page 12)

6
Figure. Cable connections
Antenna/Power Connection
Connect TV RF sources to the antenna port. TV RF signals include: receiving antenna/CATV net. You 1.
can use 75 Ohm coaxial cable to connect outdoor antenna.
Insert one end of the supplied power cord to the player’s power jack and the other end to the 110-240V 2.
AC wall outlet.
VGA Input - PC Connection
The VGA port of the TV is capable of accepting high-definition signals from computers with a VGA output
jack. When used as a computer moniter, connect the VGA jack and the PC Audio In jack with a 15-Pin D-Sub
cable and a 3.5mm stereo audio cable.
Coaxial Output - Digital Audio Output Connector
When MPEG audio or Dolby Digital audio is played, Dolby Digital bitstream or MPEG audio bitstream is
sent to the player’s digital audio output connector. When the player is connected to a Dolby or MPEG audio
decorder via this output socket, you can enjoy theater-quality audio in your home. An optical audio cable is
required when a Dolby Digital decoder or MPEG audio decoder is used.
Phone Connection
Be sure that your unit is set at a low volume level before connecting the earphone. Increase the volume
gradually for your comfortable listening.
CAUTION:
Hearing experts advise against the constant use of personal stereos played at high volume. Constant high
volume use can lead to hearing loss. If you experience ringing in the ears or hearing loss, discontinue use
and seek medical advise.
HDMI Input - AV Signal Input
HDMI (High Definition Multimedia Interface) is a new type of connection that transmits digital audio and video
signals simultaneously over a single cable. A HDMI cable is required for the HDMI connection.
These HDMI input connectors are capable of receiving video at resolutions up to 1080p (1080-progressive).
Cable Connections
External AV Source
Amplifier equipped with a Dolby
Pro Logic Surround
>
Wall Outlet
Set the unit into the relative input mode to enable the
signal pass.