Sony XR-C7200 - Manual (Page 20)

Q
Troubleshooting guide
The following checklist help vou remedy most problems you may encounter with your unit.
Before going through the checklist below, check the connection and operating procedures.
General
Problem Cause/Solution
No sound • Rotate the dial clockwise to adjust the volume.
• Set the fader control to the center position for 2-speaker
systems.
The contents of the memory
have been erased.
• The power cord or battery has been disconnected.
• The reset button has been pressed.
—► Store again into the memory.
Indications do not appear in
the display. Remove the front panel and clean the connectors. See "Cleaning
the connectors" (page 15) for details.
No beep tone. The beep tone is turned off (page 10).
Tape playback
Problem Cause/Solution
Playback sound is distorted. Confaminafion of the tape head. —► Clean the head.
The AMS does not operate
correctly. • There is noise in the space between tracks.
• A blank space is too short (less than four seconds).
•
on (SEEK/AMS) is pressed immediately before the
following tracks.
• on (SEEK/AMS) is pressed immediately after the track
starts.
• A long pause, or a passage of low frequencies or very low
sound level is treated as a blank space.
Radio reception
Problem Cause/Solution
Preset tuning is not possible. • Store the correct frequency.
• The broadcast is too weak.
Automatic tuning is not
possible. The broadcast is too weak.
—► Use manual tuning.
The "ST" indication flashes. • Tune in the frequency correctly.
• The broadcast signal is too weak.
—► Set to the monaural mode (page 8).
20