Hookups, Connecting the ac power cord, Note on placement of the player – Sony CDP-CX350 User Manual
Page 5: About the supplied remote commander, Understanding the 2 way remote system, To°i, Getting started
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting Started
Hookups
When connecting the audio cord, be sure to match the
color-coded cords to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
CD player
Amplifier
2ND CD
LINE
»
0^
1
If you have a digital component such as a digital
amplifier, D/A converter, DAT or MD
Connect the component via the DIGITAL OUT (OPTICAL)
connector using an optical cable (not supplied). Take off the
cap and plug in the optical cable.
cHI>-
POC-15
-d b’
Optical cable (not supplied)
CD player
Digital component
(
digital
out
)
[DIGITAL INPUfl
OPTICAL
OPTICAL
l/nl.
ITfll
I*^i :
1^1
Note
When you connect via the DIGITAL OUT (OPTICAL)
connector, noise may occur when you play CD software
other than music, such as a CD-ROM.
'Q' If you have a Sony component with the CONTROL A1
n jack
Connect the component via the CONTROL A1 II jack.
You can simplify the operation of audio systems
composed of separate Sony components. For details, refer
to the supplementary "CONTROL A1 II Control
System" instructions.
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
Note on placement of the player
Be sure to place the player in a flat, horizontal place.
If the player is left in a slanted position, it may cause a
malfunction or damage the player.
Opr
0
To°i
0
['
X
About the Supplied Remote
Commander
Understanding the 2 way remote system
This remote operates under a 2 way remote system.
With the 2 way remote system, the component
responds to signals sent from the remote by sending
additional signals (information about the status of the
component, text data, etc.) back to the remote. Thus,
operations are performed as a result of communication
between the remote and the component.
Component
When using a home entertainment system comprised
of several components compatible with the 2 way
remote system, please restrict 2 way remote system
operation to a single component. Normally, turn off the
2 way remote system on all components except the
receiver. If you would like to turn off the player's 2
way remote system, see "Turning off a player's
response to remote signals" on page 6.