Tips for using the battery pack, When to replace the battery pack, Notes on the rechargeable battery pack – Sony CCD-TR83 User Manual

Page 34: The battery pack heats up, Battery pack care, How to use the switch on the battery pack, The life of the battery pack, Charging temperature, Sony batteries are recommended

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Tips for Using the Battery Pack

When to Replace the Battery Pack

While you are using your camcorder, the remaining battery indicator in the viewfinder decreases
gradually as battery power is used up.

nUi

When the remaining battery indicator reaches the lowest point, the <Xi indicator appears and starts
flashing in the viewfinder

[b].

When the <Xi indicator in the viewfinder changes from slow flashing to rapid flashing while you are
recording, turn the POWER switch to OFF on the camcorder and replace the battery pack. Leave the
tape in the camcorder to obtain a smooth transition between scenes after the battery pack is replaced.

Note on the remaining battery indicator

The remaining battery indicator of the camcorder may indicate a different remaining capacity from that
of the battery pack with its own indicator (not supplied). The indicator on the battery pack is more
accurate.

Notes on the Rechargeable Battery Pack

The Battery Pack Heats Up

During charging or recording, the battery pack heats up. This is caused by energy that has been
generated and a chemical change that has occurred inside the battery pack. This is not cause for
concern.

Battery Pack Care

• Remove the battery pack from the camcorder after using the battery pack, and keep it in a cool place.

When the battery pack is attached to the camcorder, a small amount of current flows to the camcorder
even if the POWER switch is set to OFF, which shortens battery life.

■ The battery pack is always discharging even when it is not in use after charging. Therefore, you

should charge the battery pack right before using the camcorder.

How to Use the Switch on the Battery Pack

This switch is provided so that you can mark the charged battery pack. Set the switch to the "no mark"
position when charging is completed. Set the switch to the "red mark" position when the battery is
used up (or in whichever direction you want to remind yourself)

[c].

The Life of the Battery Pack

If the battery indicator flashes rapidly just after turning on the camcorder with a fully charged battery
pack, the battery pack should be replaced with a new fully charged one.

Charging Temperature

You should charge batteries at temperatures from 50
temperatures require a longer charging time.

>F to 86 °F (from 10 °C to 30 °C). Lower

Sony Batteries are Recommended

Use of non-Sony batteries may damage your Handycam camcorder.

34

Advertising