Cobra Electronics microTalk Professional 2-Way Radio - Manual (Page 2)

2 3
Operation Operation
Note
Use high quality “AA” batteries,
such as alkaline, NiMH or
Ni-Cad.
Incorrect positioning can dam-
age both the batteries and the
unit.
See Accessories on page 45.
Charge ports are located on
side of unit.
Note
When batteries are low or need
charging the ( ) BATT
LOW indicator will blink.
Replace alkaline batteries.
Battery
Installation
Pull lock tab down
and lift door up
(towards you) to
remove battery
cover. Insert six “AA” bat-
teries. Position bat-
teries according to
po l a ri ty marki n g s.
Install Batteries
Note
Wh e n ever the unit is on, yo u
can re ce i ve co m m u n i ca t i o n s.
Turning On
Your microTalk
Professional
Antenna
Turning On Your microtalk Professional
Turn the Volume control clockwise to switch
power on. Set volume to desired level. Turn the
Volume control counter-clockwise to turn
power off.
The radio is equipped
with a SMA female anten-
na connector and a
matching UHF antenna.
Place top of unit with
antenna on connector,
turning clockwise until
tight. You can replace this
antenna with an optional
mobile antenna when
using the radio inside a
car, or a base antenna in a
fixed location.
Antenna
TURN KNOB
CLOCKWISE
PLACE ON
CONNECTOR.
TURN
CLOCKWISE
Cobra PR 2000 manual M(4217)A 12/4/00 4:18 PM Page 2