T roubleshooting, Cause/solution, Troubleshooting – Sony MZ-R30 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
T roubleshooting
Should .my problem persists after you have made these cheeks, consult your nearest Sony
dealer.
Symptom
The recorder devs not tvork
or works prxirly.
Cause/Solution
• Audio sources may not be securely connected.
♦ Disconnect the audio sources once and connect
them again (pages 6,11)-
• Moisture has condensed inside the recorder.
Take the MD out and leave the recorder in a
warm place for several hours until the moisture
evaporates.
• The rechargeable battery or dry batteries are weak
(C3 or "LOW ВАТТ" flashes).
♦ Charge the rechargeable battery or replace the
dry batteries (pages 24, 25).
• The rechargeable battery or dry batteries have been
installed incorrectly.
♦
Install the batteries correctly (page 25).
• You pressed a button while the disc indication was
rotating quickly.
Wait until the indication rotates slowly.
• The recording volume is too low.
• The AC adaptor was unplugged during recording or
a power outage occurred.
• While operating, the recorder received a mechanical
shock, too much static, abnormal power voltage
caused by lightning, etc.
Restart the operation as follows.
1
Disconnect all the power sources.
2 Leave the recorder for about 30 seconds.
3 Connect the power source.
No
sound
comes
through
the headphones.
>
The headphones plug is not firmly connected.
^ Connect the headphones with a repiote controller
plug firmly to D/REMOTE.
>
Volume is too low.
Adjust the volume by pressing VOLUME +/-
(VOL +/- on the remote controller).
• AVLS is on.
♦ Slide AVLS to NOMAL (page 17).
•
An MD is not played from
the first track.
• Disc playing stopped before it came to the last track.
♦ Press repeatedly or open and close the lid
once to go back to the beginning of the disc, and
restart playing after checking the track number in
the display.
28