Camcorder, Power, Cause and/or corrective actions – Sony CCD-TR98 User Manual
Page 43: Operation, Symptom, Trouble check
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Trouble Check
If you run into any problem using the camcorder, use the following table to troubleshoot the problem.
Should the difficulty persist, disconnect the power source and contact your Sony dealer or local
authorized Sony ser\'ice facility.
Camcorder
Power
£ ^
o 5'
Symptom
Cause and/or Corrective Actions
The power is not on.
' The battery pack is not attached or not attached firmly.
Attach the battery pack firmly by pushing the lower part of
the battery pack, (p.8)
The battery is dead.
Use a charged battery pack, (p.6)
The AC power adaptor is not connected to a wall outlet.
Connect the AC power adaptor to a wall outlet. (p.l9)
The power goes off.
> While being operated in CAMERA mode, the camcorder has
been in the Standby mode for more than 5 minutes.
■> Turn STANDBY down once and turn it up again, (p.ll)
' The battery is dead.
-> Use a charged battery pack, (p.6)
The battery pack is quickly
discharged.
■ The ambient temperature is too low. (p.34)
’ The battery pack has not been charged fully.
Charge the battery pack again, (p.6)
' Tlie battery pack is completely dead, and cannot be recharged.
-> Use another battery pack, (p.35)
Operation
Symptom
Cause and/or Corrective Actions
START/STOPdoes
not
operate.
' The tape is stuck to the drum.
-> Eject the cassette, (p.9)
' The tape has run out.
Rewind the tape or use a new one. (p.l7)
’ The POWER switch is set to PLAYER.
^ Set to CAMERA. (p.lO)
‘ The tab on cassette is out (red).
Use a new cassette or slide the tab. (p.9)
The cassette cannot be
removed from the holder.
' The battery is dead.
Use a charged battery pack or the AC power adaptor, (p.6, 19)
No function except for
cassette ejection works.
Moisture condensation has occurred.
Remove the cassette and leave the camcorder for at least an
hour, (p.38)
The tape does not move w
a tape transport button is
pressed.
hen • The POWER switch is set to CAMERA or OFF.
-»Set it to PLAYER. (p.l7)
• The tape has run out.
-» Rewind the tape or use a new one. (p.l7)
(to be continued)
43