Sony SA-IF70S - Manual (Page 5)

Precaution
On safety
• Should any solid object or liquid fall into the enclosures, unplug the
speaker system and have it checked by qualified personnel before
operating it any further.
On power sources
• The AC power cord must be changed only at a qualified service shop.
• Before operating the speakers, check that the operating voltage is
identical with your local power supply. The operating voltage is
Indicated on the nameplate on the rear of the speakers.
• If you are not going to use the speakers for a long time, be sure to
disconnect the speakers from the wall outlet. To disconnect the AC
power cord, grasp the plug itself; never pull the cord.
On placement
• Do not place the speakers near heat sources, or in places subject to direct
sunlight, excessive dust or mechanical shock.
• Good ventilation is essential to prevent internal heat buildup. Place the
speakers in a location with adequate air circulation, and in a way that
does not block the rear ventilation holes.
• Placing the wireless speakers near a light bulb or in direct sunlight
may cause noise from the speakers.
On cleaning
• Clean the enclosures, panels and controls with a soft cloth slightly
moistened with a mild detergent solution. Do not use any type of
abrasive pad, scouring powder or solvent such as alcohol or benzine.
If you have any question or problem concerning your wireless
speakers, please consult your nearest Sony dealer.
Unpacking
• WIRELESS SPEAKER SYSTEM SA-IF70S (2)
• WIRELESS TRANSMITTER EMT-70(1)
Hookups
Connecting the infrared transmitter to the WIRELESS REAR SPEAKER
jack on the amplifier (□)■
Note
If your amplifier does not have a wireless rear speaker jack, use the
input adaptor IAD-IF70 (not supplied} for connection.
Connecting the AC power cord of the speaker to a wall outlet ([0).
5