Specifications, Audio power specifications, Power output and total harmonic distortion – Sony STR-D515 User Manual

Page 21: Video section, Other specifications, Amplifier section, Tuner section, General, For usa and canadian models)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Specifications

(For USA and Canadian models)

Audio Power Specifications

POWER OUTPUT AND TOTAL HARMONIC DISTORTION

With 8-ohnn load, both channels
driven, from 40 - 20,000 Hz, rated 100
watts (STR-D615) or 70 watts (STR-

D515) per channel minimum RMS
power, with less than 0.8% total
harmonic distortion from 250
milliwatts to rated output.

SUR (surround) MODE (8 ohms, less than 0.8% total harmonic
distortion)

Video section

STR-D615

STR-D515

FRONT

70 W pier channel

70 W per channel

CENTER (only in the

DOLBY mode)

70 W

20 W

REAR (Spk. Parallel
use)

20 W

20 W

Other Specifications

Amplifier section

Continuous RMS power output (8 ohms, at 40 Hz - 20 kHz less than
0.8% total harmonic distortion)

STR-D615:100 W + 100 W (FRONT)
STR-D515: 70 W + 70 W

Dynamic power (at 1 kHz IHF) (FRONT)

STR-D615; 140 W + 140 W (8 ohms), 210 W + 210 W (4 ohms)
STR-D515; 95 W + 95 W (8 ohms), 140 W + 140 W (4 ohms)

Harmonic distortion

Less than 0.8% at rated output

Frequency response

PHONO: RIAA equalization curve ±0.5 dB
CD -|

VIDEO

10 Hz - 50 kHz ±1 dB

TAPE

-I

Inputs

Sensitivity

Impedance

S/N (weighting

network, mputlevel)

PHONO

2.5 mV

50 kilohms

75 dB (A)
75 dB* (A, 5.0 mV)

CD

300 mV

50 kilohms

82dB(A)
82 dB» (A, 500 mV)

VIDEO,
TV/LD
TAPE/MD

250 mV

»'78 IHF

Outputs

REC OUT, VIDEO
(AUDIO) OUT

Voltage 250 mV
Imjjedance 10 kilohms

HEADPHONES

Accepts low and high impedance
headphones

Tone controls

BASS; ±8 dB at 100 Hz

TREBLE:+8 dB at 10 kHz

Muting

-20 dB

LOW BOOST

+10 dB at 70 Hz

INPUT

VIDEO,

TV/LD

1 Vp-p 75 ohms

OUTPUT

VIDEO
MONITOR

1 Vp-p 75 ohms

Tuner section

FM tuner section

AM tuner section

Tuning range

87.5 —108 MHz

530 -1710 kHz
(10 kHz step)»»
531 -1710 kHz
(9 kHz step)

Anterma
terminals

300 ohms,balanced
75 ohms, unbalanced

External anterma
terminal

Sensitivity at

50 dB quieting

18.3 dBf, 4.5 pV (mono)

38.3 dBf, 45 pV (stereo)

Usable

sensitivity

11.2 dBf, 2 pV (IHF)

Loop antenna:
500 pV (at 1,000 kHz)

Signal-to-noise
ratio

76 dB (mono)

70 dB (stereo)

54 dB (at 50 mV/m)

Harmonic
distortion

0.3% (mono), 0.5%
(stereo) at 1 kHz

0.5%(at50mV/m,
400 Hz)

Selectivity

60 dB at 400 kHz

40 dB at 10 kHz

Separation

45 dB at 1 kHz

Frequency
response

30 Hz —15 kHz

»0^ dB

-2

General

System

Tuner section: PLL quartz-locked digital

synthesizer system

Preamplifier section: low-noise NF type equalizer amp
Power amplifier section: pure complementary SEPP

Power requirements

120 V AC, 60 Hz

Power consumption

U.S.A. model: 186 W (STR-D615)

170W(STR-D515)

Canadian model: 290 VA (STR-D615)

195 W (STR-D515)

AC outlet

One switched (120 W/IA Max.)

Dimensions

Approx. 430

X

135

X

295 mm (w/h/d)

(17 X 5 ’/j X11 ’/j inches)

including projecting parts and controls

Mass

Approx. 7.2 kg (16 lb 2 oz) (STR-D615)

Approx. 6.3 kg (13 lb 15 oz) (STR-D515)

Accessories supplied

FM wire antenna (1)
AM loop antenna (1)

Remote Commander RM-U242 (1)

Sony batteries SUM-3(NS) (2)

Design and specifications are subject to change without notice.

*» For the models in U.S.A. and Canada

You can change the AM tuning interval to 9 kHz. After tuning in
any AM tuning in any AM station, turn off the power of receiver
once. While holding down the TUNING + button, press the
POWER switch. When you change the interval, all the preset
stations will be erased. To reset the interval, repeat the same
procedure.

^ ,|

Advertising
This manual is related to the following products: