Campbell Hausfeld IRONFORCE IFK003 User Manual
Notice
• NOTICE •
This spray gun is shipped in Siphon Feed mode, used for
a finer finish with light materials. To use the gun with
high-viscosity materials such as latex paint, use the
Pressure Feed mode.
To change from Siphon Feed to Pressure Feed mode,
turn the knob shown above from ‘S’ to ‘P’ until finger
tight.
Thoroughly mix the material in accordance with the
manufacturer’s instructions. If necessary, thin per paint
manufacturer’s instructions.
IN170233AV 7/03
© 2003 Campbell Hausfeld/Scott Fetzer
For parts, product & service information
visit www.chpower.com
IFK003
S
P
P S
• NOTICE •
This spray gun is shipped in Siphon Feed mode, used for
a finer finish with light materials. To use the gun with
high-viscosity materials such as latex paint, use the
Pressure Feed mode.
To change from Siphon Feed to Pressure Feed mode,
turn the knob shown above from ‘S’ to ‘P’ until finger
tight.
Thoroughly mix the material in accordance with the
manufacturer’s instructions. If necessary, thin per paint
manufacturer’s instructions.
IN170233AV 7/03
© 2003 Campbell Hausfeld/Scott Fetzer
For parts, product & service information
visit www.chpower.com
IFK003
S
P
P S