Sony ICF-CD2000 - Manual (Page 11)

Handle compact discs...
...this way.
Handle the disc by
its edge.
Not this way
Do not touch the
surface.
Do not stick paper
or tape nor write
anything on the
surface.
Notes
• Do not open the CD compartment lid during
playback, as doing so may damage the disc.
• If you press CD Wl with no disc in the CD
compartment, "00" will flash for a few
seconds.
Various Modes of CD
Playback
You can play tracks repeatedly or in random
order.
Press CD PLAY MODE repeatedly to
select a playback mode.
Each press changes the playback mode as
follows:
Display Play Mode
none (normal play)
All the tracks are played once.
"SHUFFLE" (shuffle play)
AH the tracks are played once in random order.
"SHUFFLE (shuffle repeat)
REPEAT ALL"
All the tracks are played repeatedly in random
order.
♦
"REPEAT 1" (single repeat)
A single track is played repeatedly.
"REPEAT ALL" (all repeat)
All the tracks are played repeatedly.
L
Notes
• When playing a CD in the Shuffle mode,
pressing will not shift playback to the
preceding track.
• The CD PLAY MODE button does not function
when the main cover is closed.
Playing the Radio
Manual Tuning
1 Press RADIO*SLEEP to turn on the
radio.
2 Press BAND repeatedly to select the
desired band.
FMl and FM2 are differentiated only for
Preset tuning. For Manual or Auto Station
Scan timing of FM stations, select either
band.
3 Tune in to a station by pressing TONE/
SCAN TIME SET + or -.
Press + for a higher frequency and - for a
lower frequency. To change the frequency
rapidly, hold down the button for more than
2 seconds. Be sure "SCAN" does not appear
in the display. The frequency indication will
stop when you release the button.
4 Adjust the volume using VOLUME.
Listening through the built-in
speakers
The built-in speakers are located in the inner side
of the main cover. Open the main cover to listen
through the speakers.
Note
When a headphone set is cormected to the 0
(headphones) jack, there will be no sound from
the speakers.
To turn off the radio
Press
HOFF'ALARM RESET.
To improve radio reception
FM: Extend and adjust the angle of the telescopic
antenna.
AM: Rotate the unit horizontally for optimum
reception. A ferrite bar is built in to the unit.
Avoid operating the unit on a steel desk or
metal surface.
Auto Station Scan
Tuning
The unit automatically scans the selected
waveband and stops at reception.
1 Press RADIO«SLEEP to turn on the
radio.
2 Press BAND repeatedly to select the
desired band.
3 Hold down TUNE/SCAN TIME SET +
or - until "SCAN" flashes in the
display, then release the button.
Scanning starts.
Scanning is paused when a station is
received. The station is tuned in for a few
seconds, then the unit resumes scanning.
4 Press TUNE/SCAN TIME SET + or -
while your desired station is tuned in.
"SCAN" disappears in the display and
scanning stops to receive your desired station
continuously.
5 Adjust the volume using VOLUME.