Sony CCD-TR54 - Manual (Page 41)

Precautions
Camcordei' Operation
• Operate the camcorder using 6.0 V (battery pack), or 7.5 V (AC power adaptor).
• For DC or AC operation, use onlv tiie recommended accessories.
• Sliould any solid object or liquid lal! into the casing, unplug the camcorder and have it checked bv your
nearest Srany dealer before operating it anv further.
• Avoid rough handling or mechanical shock. Be particularly careful of the lens.
• Keep the POWER switcii set to OFF when not using the camera.
• Do not wrap up the camcorder and operate it since heat may build up internally.
• Keep the camcorder awav from strong magnetic fields or mechanical vibration.
On Handling Tapes
Do not insert anything into the small holes on the rear of the cassette. These holes are used to sense the
type, thickness of tape, or if the tab is out or in.
Camcorder Care
• When the camcorder is not to be used for a long time, disconnect the power source and remove the
cassette. Periodically turn on the power, operate the camera and player stations and play back a tape
for about 3 minutes.
• Clean the lens with a soft brush to remove dust. If there are fingerprints on the lens, remove then', with
a soft cloth.
• Clean the camcorder body 'vith a soft dry cloth, or a soft cloth lightly moistened with a mild detergent
solution. Do not use anv tvpe of solvent which may damage the finish.
AC Power Adaptor
Charging
• Use only for the sjaecified battery pack. This unit cannot be used to charge a lithium ion type battery.
• Attach the battery pack firmly.
• Charge the battery pack on a flat surface without vibration.
Others
• Unplug the unit from the \\'all (mains) outlet when not in use for a long time. To disconnect the cord
(mains lead), pull it out by the plug. Never pull the cord itself.
• Do not operate the unit with a damaged cord or if the unit has been dropped or damaged.
• Do not bend the AC power cord (mains lead) forcibly, or put a heavy object on it. This will damage the
cord and may cause a fire or an electrical shock.
• Be sure that nothing metallic comes into contact with the metal parts of the connecting plate. If this
happens, a short may occur and the unit may he damaged.
• Always keep the metal contacts clean.
• Do not disassemble the unit.
• Do not apply mechanical shock or drop the unit.
• While the unit is in use, particularly during charging, keep it away from AM receivers and video
equipment because it will disturb AM reception and video operation.
• The unit becomes warm u hile in use. This is normal.
• Do not place the unit in locations that are:
- Extremely hot or cold
- Dusty or dirty
- Very humid
- Vibrating
If any difficulty should arise, unplug the unit and contact your nearest Sony dealer.
41