Sony TC-WE435 - Manual (Page 17)

Additional Information
Specifications
System
Recording system
4-track 2-channel stereo
Fast-winding time (approx.)
■■ 100 sec. (with Sony C-60 cassette)
Bias
AC bias
Signal-to-noise ratio (at peak level and weighted with Dolby NR off)
Type I tape, Sony Type I (NORMAL): 55 dB
Type II tape, Sony Type II (HIGH): 57 dB
Type IV tape, Sony Type IV (METAL): 58 dB
S/N ratio improvement (approximate values)
With Dolby B NR on: 5 dB at 1 kHz, 10 dB at 5 kHz
With Dolby C NR on: 15 dB at 500 Hz, 20 dB at 1 kHz
Harmonic distortion
0.4% (with Type I tape, Sony Type I (NORMAL):
160 nWb/m 315 Hz, 3rd H.D.)
1.8% (with Type IV tape, Sony Type IV (METAL):
250 nWb/m 315 Hz, 3rd H.D.)
Frequency response (Dolby NR off)
Type I tape, Sony Type I (NORMAL): 30 -16,000 Hz
(±3 dB, lEC)
Type II tape, Sony Type II (HIGH): 30 - 17,000 Hz
(±3 dB.IEC)
Type IV tape, Sony Type IV (METAL): 30 - 19,000 Hz
(±3 dB, lEC)
30 - 13,000 Hz (±3 dB, -i dB recording)
Type I tape, Sony Type I (NORMAL): 20 - 17,000 Hz
(±6 dB)
Type II tape, Sony Type II (HIGH): 20 - 18,000 Hz
(±6 dB)
Type IV tape, Sony Type IV (METAL): 20 - 20,000 Hz
(±6 dB)
Wow and flutter
±0.15% W. Peak (lEC)
0.1% W. RMS (NAB)
±0.2% W. Peak (DIN)
Inputs
Line inputs (phono jacks)
Sensitivity: 0.16 V
Input impedance: 47 kilohms
General
Power requirements
Where purchased Power requirements
U.S.A. and Canada 120 V AC, 60 Hz
U.K., Continental
Europe, China and
certain countries in
Asia 220-230 VAC, 50/60 Hz
Australia 240 V AC, 50/60 Hz
Other countries 120/220/230 - 240 V AC, 50/60 Hz
Power consumption
18 W
Dimensions (approx.) (w/h/d)
Model for U.K. and Australia:
430 X 120 X 310 mm
Model for other countries:
430 X 120 X 290 mm (17 x 4 Vj x 11 '/: in.)
including projecting parts and controls
Mass (approx.)
4 kg (8 lbs 13 oz)
Supplied accessories
See page 4.
Optional accessory
Remote commander RM-J910
For more information on the availability of the remote
commander, contact your nearest Sony dealer.
Design and specifications are subject to change without
notice.
Outputs
Line outputs (phono jacks)
Rated output level: 0.5 V at a load impedance of
47 kilohms
Load impedance: Over 10 kilohms
Headphones (stereo phone jack)
Output level: 0.25 mW at a load impedance of
32 ohms
1 7