General setup information, Continued – Sony SLV-798HF User Manual
Page 82
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Additional Information
General setup information
Setting the RF unit
Wlion connoctiiij; tho \’CR to the T\'
using only tho antenna cable, vou must
set tlie RF UNIT switch on the rear ofThe
VCR so that the TV can receiye the
correct signal from the \'CR.
TV
TV/VIDEO
CHANNEL+/-
1
Set the RF UNIT switch on the rear of the VCR to CFI3 or CH4,
whichever channel is not used in your area. If both are used, sgt the
switch to either channel.
2
Press POWER to turn on the VCR.
3
Press TV/VIDEO to turn on the VIDEO indicator in the VCR's display
window.
4
Press CHANNEL +/- to display a channel number in the display
window. Select an active channel number in your area.
5
Turn on vour TV and set it to the channel vou selected in step 1
(channel 3 or 4).
The selected TV channel broadcast appears on the TV screen. If the
channels change when you press CHANNEL +/- on the VCR, you
have made the correct setting.
Whenever you use the VCR, set the TV to the channel selected in step 1.
continued
Additional Information
83