Cobra Electronics 25 WX NW ST - Manual (Page 10)

To Transmit
19
To Transmit
Transmit
18
Caution!
Be sure the antenna is properly
connected to the radio before
transmitting. Prolonged trans-
mitting without an antenna,or
a poorly matched antenna,
could cause damage to the
transmitter.
Be sure to read the F.C.C. Rules
and Regulations included with
this unit before transmitting.
Operation Operation
Select desired channel. 1
Transmit
Push and hold mic button to transmit.
Transmitter is now activated. When transmit-
ting, hold the microphone two inches from
your mouth and speak in a clear, normal voice.
Release to receive. 1
RF Meter RF Meter
This meter swings proportionately to the RF
output (outgoing signal) while transmitting.
External Speaker External Speaker
The external Speaker jack is used for remot e
receiver monitoring.
Note
The external speaker should
have 8-ohm impedance and be
rated to handle at least 4.0
watts. When the external speak-
er is plugged in,the internal
speaker is automatically discon-
nected.
Note
Cobra external speakers are
rated at 10 watts.See
Accessories page 39.
Connect an external speaker to the external
speaker jack on the rear panel. 1
25 WX NW ST Manual 3.3 6/15/99 1:10 PM Page 18