Document Outline

• FM Stereo FM-AM Receiver
  • WARNING
    • To prevent fire or shock hazard, do not expose the unit to rain or moisture.
      • IMPORTANT
      • CAUTION
      • Note to CATV system installer
      • Owner's record
      • For the customers in Canada
      • CAUTION
  • Precautions
    • On safety
    • On placement
    • On operation
    • On cleaning
  • About This Manual
    • Getting Started
    • Receiver Operations
    • Additional Information
    • Remote Button Descriptions 19
    • Quick Reference Guide Back cover
    • Inserting batteries into the remote
      • V When to replace batteries
      • Notes
  • Hookup Overview
    • Before you get started
  • Antenna Hookups
    • Overview
    • Connecting a ground wire
    • Hookups
  • Audio Component Hookups
    • Overview
      • (continued)
      • Turntable
      • If your turntable has an earth lead
      • Tape deck or MD recorder
      • What cords will I need?
    • Hookups
      • Front speakers
  • Speaker System Hookups
    • Overview
      • Active woofer (STR-D665 only)
      • 'Q' If you have an additional front speaker system
      • If your TV monitor uses separate speakers
    • Selecting the speaker system
  • TV/VCR Hookups
    • Overview
      • MONITOR
    • Connecting the AC power cord
  • Before You Use Your Receiver
  • Selecting a Component
    • Watching video programs
    • Using the remote Ll
      • If the component does not turn on
      • To turn off the components
      • 'Q' If you use a Sony TV
      • ■Q' When you watch TV without using the receiver (only for Sony TVs)
    • Operating one component while using another (Background Operation)
    • Changing the factory setting of a function button
      • To reset the setting to the factory setting
  • Receiving Broadcasts
    • To receive other stations
    • 'Q' If the STEREO indicator remains off
    • 'Q' If an FM stereo program is distorted
    • If you cannot tune in a station and the entered numbers are flashing
    • To watch FM simulcast TV programs
    • 'Q' If you enter a frequency not covered by the tuning interval
    • Receiving broadcasts by scanning stations (automatic tuning)
  • Presetting Radio Stations
    • (continued)
    • If "MEMORY" disappears, start again from step 3.
    • To change a preset station
    • Note
    • Tuning preset stations (preset tuning)
      • ■p'You can tune by scanning the preset stations
    • Recording on an audio tape or MiniDisc
    • Recording on a video tape
    • 1
      • 'Q' You can replace audio while copying a laser disc
  • Choosing a Surround Mode
    • To turn off surround sound
    • 'Q' You can find Dolby Surround-encoded software by looking at the packaging
    • Note
  • Getting the Most Out of Dolby Pro Logic Surround Sound
    • (continued)
    • Selecting the center mode
    • Adjusting the speaker volume Ll
      • ■Q' You can adjust all speakers at one time
      • 'Q' You can also adjust the volume level with the controls on the receiver
      • 'Q' You can increase the output level of the rear speakers
    • Adjusting the delay time
  • Troubleshooting
    • There's no sound or only a very low-level sound is heard.
    • The left and right sounds are unbalanced or reversed.
    • Severe hum or noise is heard.
    • No sound is heard from the center speaker.
    • No sound or only a very low-level sound is heard from the rear speakers.
    • Radio stations cannot be tuned in.
    • Surround effect cannot be obtained.
    • No picture or an unclear picture is seen on the TV screen.
    • Recording cannot be made.
    • The remote does not function.
  • Specifications
    • Audio power specifications
    • Amplifier section
    • Video section
    • General
  • Glossary
  • Index
    • A,B
    • E,F,G
    • H, I, J, K, u M
    • N, O
    • u, V
    • W, X, Y, Z
  • Rear Panel Descriptions
  • Remote Button Descriptions
  • Receiving Broadcasts Presetting Radio
  • Scanning Radio Receiving Preset
  • Scanning Preset Stations