Connection 1, Connection 2 – LG 200LC1R User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
V : ;
h
S
ì
: ;
i
: >
- I n
Video mode, TV
automatically reverts to TV
mode
if
the
TV
buttons are pressed.
Connection 1
Set VCR switch to 3 or 4 and then tune TV to
the same channel number.
Connection 2
1. Connect the
audio/video
output jacks on VCR
to the corresponding input jacks on the TV.
When connecting the TV to a VCR, match the
jack colors (Video = yellow, Audio Left =
white, and Audio Right = red).
2. Insert
a
video tape into the VCR and
press
PLAY on the VCR. (Refer to the VCR owner's
manual.)
3. Use the
INPUT
button on the remote control
to select
Video.
(If connected to S-VIDEO on
rear panel, select the
Video
external input
source.)
!h;l..|!: -V .'-!('ti.,|;
- After subscribing to
a local
cable TV service and installing a converter, you can watch cable TV programming.
- For further cable TV
information,
contact a local cable service provider.
Connection 1
1. Select 3 or 4 with channel switch on cable box.
2.
Tune the TV channel to the same selected output channel of
cable box.
3. Select channels at the cable box or with the cable box remote control.
Connection 2
1.
Connect the audio/video output
jacks
on Cable Box to the corre
sponding
input
jacks
on
the
TV.
When
connecting
the
TV
to
Cable
Box, match the jack colors
(Video = yellow. Audio Left = white, and Audio Right = red).
2. Use the INPUT button on the remote control to select
Video.
3. Select channels with the cable box remote control.
13