Casablanca Fan Company Candelier Ceiling Fan C16G73T - Manual (Page 6)

6
INSTALLING DOWNROD
Step 4a. Unscrew and remove both pieces of the control
housing cover. Set the control housing cover and six
screws aside. You will re-install the control housing
cover in Step 4e.
Step 4b. Unscrew and remove cross bolt and nut from
downrod adapter tube in center of control housing.
Step 4c. Thread black, white, and green wires up through
downrod, tightening to the base of the downrod adapter
tube in the control housing structure.
Step 4d. Slide downrod into downrod adapter tube
making sure no wires are pinched. Place your thumb on
the end of the cross-bolt. Insert the cross-bolt until its fl at
end is fl ush with the downrod adaptor tube. Re-attach the
nut, and tighten fi rmly with 7/16" wrench.
NOTE: Be careful not to cut or pinch the wires when
inserting the cross-bolt.
Step 4e. Use the parts you set aside in Step 4a to replace
the control housing cover and screw it back into place.
NOTE: You will need at least two assistants for this
step.
Step 5a. Have your assistant(s) help you lift the Candelier
fi xture to the ceiling.
Step 5b. Insert the downrod ball into opening in the
crossbar hanging bracket.
Step 5c. Slide the hanging bracket support ring up the
hanging bracket, and screw it into place using the three
#8-32 x 1/4" screws.
HANGING THE FAN
Cross Bolt
and Nut