Craftsman 917.272230 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

• The attachments can be used during

the engine warm-up period and may
require the choke control be pulled out
slightly,

NOTE; If at a high attitude (above 3000 feet)
or in cotd tempCTatures (below 32 F) the
carburetor fuel mixture may need to be
ac^usted for best engine pOTormance, See
"TO ADJUST CARBURETOR" in the Service
and A(|ustments section of this manual.

MOWINGTIPS
• Mower should be properly leveled for

best mowing performance. See “TO
LEVEL MOWER HOUSING” in the
Service and Adjustments section of this
manual.

• The left hand side of mower should be

used for trimming.

• Drive so that clippings are discharged

onto the area that has been cut. Have
the cut area to the right of the tractor.
This will result in a more even distribu­
tion of clippings and more uniform

cutting.

• When mowing large areas, start by

turning to the right so that clippings will
discharge away from shrubs, fences,

driveways, etc. After one or two rounds,
mow in the opposite direction making
left hand turns until finished.

If grass is extremely tall, it should be

mowed twice to reduce load and
possible fire hazard from dried dip­
pings. Make first cut relatively high; the

second to the desired height.

Do not mow grass when it is wet. Wet

grass will plug mower and leave
undesirable clumps. Allow grass to dry
before mowing.
Always operate engine at full throttle

when mowing to assure better mowing

performance and proper discharge of
material. Regulate ground speed by
selecting a low enough gear to give the
mower the best cutting performance as

well as the quality of cut desired.

When operating attachments, select a
ground speed that will suit the terrain
and give best performance of the
attachment being used.

18

Advertising