Maintenance, Maintenance schedule, Care and maintenance task – Craftsman C944.511573 User Manual
Page 9: Generalrecommendations, Check for loose fasteners and parts, Check for damaged or worn parts, Inspect and clean unit and decals, Blade maintenance
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Depth Adjustment
Knob
'
1. Loosen the depth adjustment knob.
2. Slide the wheel to the desired posi
tion.
• Raising the wheel wil! increase
the cutting depth.
• Lowering the wheel will decrease
the cutting depth.
3. Tighten the depth adjustment knob
securely.
MAINTENANCE
MAINTENANCE SCHEDULE
^ WARNING:
Always stop unit and disconnect spark plug wire (or discon
nect powerhead from power source) before performing maintenance.
CARE AND MAINTENANCE TASK
WHEN TO PERFORM
Check for loose fasteners and parts
Before each use
Check for damaged or worn parts
Before each use
Inspect and dean unit and decals
After each use
Check or replace blade
Every 5 hours of operation
GENERALRECOMMENDATIONS
The warranty on this attachment does
not cover items that have been sub
jected to operator abuse or negli
gence. To receive full value from the
warranty, the operator must maintain
the edger attachment as instructed in
this manual.
CHECK FOR LOOSE
FASTENERS AND PARTS
• Blade nut
• Fasteners
CHECK FOR DAMAGED OR
WORN PARTS
Contact Sears Service Centre for re
placement of damaged or worn parts,
• Blade Shield - Discontinue use of
edger if blade shield is damaged,
INSPECT AND CLEAN UNIT AND
DECALS
• After each use, inspect complete
unit for loose or damaged parts.
Clean the unit and decals using a
damp cloth with a mild detergent.
• Wipe off unit with a clean dry cloth.
BLADE MAINTENANCE
^WARNING: The blade will con
tinue to spin after the engine stops or
after the throttle trigger has been re
leased. To avoid serious injury, make
sure the blade has stopped coasting
and disconnect the spark plug (or dis
connect powerhead from power
source) before performing work on the
blade.
^WARNING: Always replace a
blade that is bent, warped, cracked,
broken, or damaged in any other way.
Never attempt to straighten and reuse
a damaged blade. Use only specified
replacement blade. Wear protective
gloves when handling or performing
maintenance on the blade to help
avoid injury.
• The blade is reversible. When the
cutting edge on one side becomes
worn, turn the blade over (see
BLADE REPLACEMENT in the SER
VICE AND ADJUSTMENTS section).
• Check blade for flatness periodically.
Lay the blade on a flat surface to in
spect for flatness. Throw away a
blade that is not flat.