Service and adjustment – Craftsman 917.273373 User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CLEANING

® Clean engine, battery, seat, finish, etc.

of ali foreign matter.

• Keep finished surfaces and wheels free

of all gasoline, oil, etc,

• Protect painted surfaces with auto­

motive type wax.

We do not recommend using a garden

hose or pressure washer to clean your

tractor unless the engine and transmis­
sion are covered to keep water out. Water

in engine or transmission will shorten the
useful life of your tractor. Use compressed

air or a leaf blower to remove grass,

leaves and trash from tractor and mower.

SERVICE AND ADJUSTMENT

A

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY

SERVICE OR ADJUSTMENTS:

1. Depress clutch/brake pedal fully and set parking brake.

2. Place gearshift lever in neutral (N) position,

3. Place attachment dutch in “DISENGAGED” position.

4. Turn ignition key to “STOP” and remove key.
5. Make sure the blades and ali moving parts have completely stopped.

6. Disconnect spark plug wire from spark plug and place wire where it cannot

come in contact with plug.

TRACTOR

TO REMOVE MOWER

Mower will be easier to remove from the
right side of tractor.

1, Place attachment dutch in “DISEN­

GAGED” position.

2. Move attachment lift lever forward to

lower mower to its lowest position.
Roll belt off engine pulley.
Remove small retainer spring, and
remove clutch spring off pulley bolt.
Remove large retainer spring, slide

collar off and push housing guide out

of bracket.

Disconnect anti-sway bar from chassis
bracket by removing retainer spring.

7.

8

.

3,

4,

5,

6

.

Disconnect suspension arms from rear

deck brackets by removing retainer
springs.

Disconnect front links from deck by
removing retainer springs.

9. Raise lift lever to raise suspension

arms. Slide mower out from under trac­
tor.

IMPORTANT: If an attachment other than

the mower deck is to be mounted on the
tractor, remove the front links and hook
the dutch spring Into square hole in frame.
TO INSTALL MOWER

1. Raise attachment lift lever to its highest

position.

Small Retainer Spring

Clutch Spring

Small Retainer Spring

Clutch Spring

Retainer Spring

Anti-Sway Bar

Collar­

Housing
Guide

Front Link

—^ Square Hole

Engine Pulley

Retainer Springs
(Both Sides)

Deflector Shield

Large Retainer Spring

Advertising