Q =off i =on, Accessory storage, Operation – Craftsman 113.179650 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Accessory Storage
Your accessories may be stored in the
storage locations on the caster feet. The
hose may be stored by wrapping it
around the unit as shown.
Operation
A WARNING: To reduce the risk of fire, expiosion, or damage to Vac:
Do not leave Vac running while unattended - you may fail to notice important signs
indicating abnormal operation such as ioss of suction, debris/iiquid exiting exhaust,
or abnormal motor noises. Immediately stop using Vac if you notice these signs.
Do not leave Vac plugged-in when not in use.
Do not continue running when fioat has cut off suction.
Do not operate Vac in areas with flammable gases, vapors or explosive dust in the air.
Sparks inside the motor can ignite airborne flammables. Flammable gases and
vapors include: lighter fluid, solvent-type cleaners, oil-based paints, gasoline,
alcohoi, or aerosoi sprays. Flammabie dusts inciude: coal, magnesium, aluminum,
grain, or gun powder.
Do not vacuum up explosive dusts, fiammabie iiquids, or hot ashes.
Do not use Vac as a sprayer.
A WARNING: To reduce the risk of electric shock or injury:
Do not expose to rain or aliow liquid to enter motor compartment. Store indoors.
Do not handle plug, switch, or Vac with wet hands.
Do not service Vac while it is plugged-in. If your Vac is not working as it should, has
missing parts, has been dropped, damaged, left outdoors, or dropped into water,
return it to an independent service center or call customer service.
When using an extension cord, use only outdoor-rated cords that are in good
condition. Do not aliow the connection to come into contact with liquid.
Do not vacuum toxic materials to reduce the risk of inhaling the vapors or dust.
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other). This plug will fit
in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a
qualified electrician to install the proper
outlet. Do not change the plug in any way.
After you plug the power cord into the
outlet, turn the unit on by pushing the
switch from position "O" to position "I".
The symbols used on the switch actuator
are international "On & Off" symbols. "O"
is the symbol for "OFF" and "I" is the
symbol for "ON".
Q
= O F F I = O N