How to order replacement parts, Trouble shooting – Craftsman 247.797855 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE(S)
CORRECTIVE ACTION
Engine fails to start
® Fuel tank empty, or stale fuel.
® Spark plug wire disconnected.
® Faulty spark plug.
® Fill tank with clean, fresh fuel
® Connect wire to spark plug,
® Clean, adjust gap or replace.
Loss of powori
operation erratic
® Spark plug wire loose.
® Unit running on CHOKE
e Slocked fuel line or stale fuel
© Water or dirt in fuel system
© Carburetor out of adjustment,
® Dirty air cleaner.
® Connect and tighten spark plug wire
® Move choke lever to OFF position
® Clean fuel line; till tank with clean
fresh gasoline.
® Disconnect fuel line at carburetor to drain fuel
tank, Refill with fresh fuel.
® Adjust carburetor or contact your SEARS
Service Center.
® Service air cleaner. See Customer Responsibilities
section of this manual.
Engine overheats
® Carburetor not adjusted
properly.
® Engine oil level low.
® Contact your SEARS Service Center.
® Fill crankcase with proper oil.
Too much vibration
© Loose parts or damaged
impeller.
® Stop engine immediately and disconnect
spark plug wire Tighten all bolts and nuts.
Make all necessary repairs. If vibration continues,
have unit serviced by a SEARS Service Center.
Unit does not
discharge
^ DiscfiarQ© chut© cloggsd.
^ Foreign object lodged in tmpeiier
® Stop engine immediately and disconnect
spark plug wire Ciean flail screen and inside
of blower housing. See Service/Adjustments
section of this manual,
® Stop engine immediately and disconnect
spark plug wire. Remove lodged object.
Rate of discharge
siows considerably or
composition of
discharged material
changes
^ Shredding bisde end/or chipper
blades dull.
® Sharpen or replace shredding and chipper
blades,.
NOTE: For repairs beyond the minor adjustments listed above, please contact your nearest SEARS Service Center.
HOW TO ORDER REPLACEMENT PARTS
Each
chipper-shredder
has
its
own
model
number
Each engine has its own model number.
The
model
number
for
your
chipper-shredder
will
be
found on a label attached to the frame
The model number lor the engine will be found on the
blower housing of the engine.
All parts listed herein may be ordered through Sears,
Roebuck
and
Co.
Service
Centers
and
most
Retail
Stores.
WHEN ORDERING REPAIR PARTS, ALWAYS GIVE
THE FOLLOWING INFORMATION:
‘PRODUCT • “5 H.P. Chipper-Shredder"
‘MODEL NUMBER - 247.797854
247,797855
‘ENGINE MODEL NO. -135212-0272-01
135212-0140-01
‘PART NUMBER
‘PART DESCRIPTION
Your
Sears
merchandise
has
added
value
when
you
consider
that
Sears
has
service
units
nationwide
staffed
with
Sears
trained
technicians.,.professional
technicians
specifically
trained
on
Sears
products,
having
the
parts,
tools
and
the
equipment
to
insure
that we meet our pledge to you ,“we service what we
sell.”
16